Tanks & Kits

Aquarium Substrate Calculator: How Much Sand, Gravel or Soil?

TankAndFin is reader-supported. If you buy through our links we may earn a commission at no extra cost to you. As an Amazon Associate we earn from qualifying purchases. Disclosure.

Short versionSubstrate is bought by volume, so measure the floor of the tank, not its gallons. Length x width x bed depth (in inches) gives cubic inches. For sand, CaribSea's own formula divides that by 1,728 and multiplies by density: 95 pounds per cubic foot for its Super Naturals sands. A standard 20 gallon high tank with a 2 inch bed needs about 33 pounds of that sand, or about 10 liters of plant soil. The calculator below does the math and counts the bags.

Rules like "a pound per gallon" get you close on an ordinary tank and badly wrong on a long, shallow one. The floor area and the depth you want are what set the amount. This calculator uses plain geometry plus the density CaribSea publishes for its sand, so the pounds figure applies to that sand. Which substrate to choose is a separate question, covered in aquarium substrate: sand, gravel or plant soil.

Aquarium substrate calculator

0liters of substrate
0cubic inches
0lb of CaribSea Super Naturals sand
03 liter bags of soil

How the numbers are worked out

ResultFormulaWhere it comes from
Cubic incheslength x width x average depthGeometry
Literscubic inches x 0.016387NIST conversion tables
Pounds of sandcubic inches / 1,728 x 95CaribSea's FAQ formula and its listed density
Bagsamount / bag size, rounded upBag sizes from the makers

CaribSea's FAQ gives the method in its own words: "In inches: Length x Width x Bed Depth Desired. Then divide by 1,728. Then multiply by the approximate substrate density." Its freshwater page lists Moonlight Sand and Crystal River at "Average Density: 95 pounds per cubic foot," and that is the figure used here. The same FAQ rounds its Super Naturals line to 100, so expect the real answer to land within about 5% either way.

Measure the inside of the glass. The standard sizes in the menu are Aqueon's published outside dimensions, so they run slightly high, which leaves a small margin.

Standard tanks, worked out

Liters and pounds of CaribSea Super Naturals sand for a flat bed, from Aqueon's standard tank footprints. The arithmetic is ours.

TankFootprint (L x W, in.)1 inch bed2 inch bed3 L soil bags for 2 in.
5.5 gallon16 3/16 x 8 3/82.2 L / 7 lb4.4 L / 15 lb2
10 gallon20 1/4 x 10 1/23.5 L / 12 lb7.0 L / 23 lb3
20 gallon high24 1/4 x 12 1/25.0 L / 17 lb9.9 L / 33 lb4
20 gallon long and 29 gallon30 1/4 x 12 1/26.2 L / 21 lb12.4 L / 42 lb5
40 gallon breeder36 3/16 x 18 1/410.8 L / 36 lb21.6 L / 73 lb8
55 gallon48 1/4 x 12 3/410.1 L / 34 lb20.2 L / 68 lb7
75 gallon48 1/2 x 18 1/214.7 L / 49 lb29.4 L / 99 lb10

Two things stand out. The 20 long and the 29 gallon share a footprint, so they take the same substrate even though one holds 9 more gallons. And the 40 breeder needs more than the 55, because it is 18 1/4 inches front to back against 12 3/4. Gallons are a poor guide to substrate; floor area is what counts.

How deep should the bed be?

None of the makers on this page publishes a required depth. Seachem's and CaribSea's calculators both ask for the depth you want. The nearest thing to a recommendation is UNS's application guide for Controsoil, which pairs 10 liters with a 20 gallon tank. Spread over a standard 20 gallon high footprint of about 303 square inches, 10 liters makes a bed almost exactly 2 inches deep (our arithmetic), which is why the calculator starts at 2.

A slope that rises toward the back is a common layout for planted tanks. Enter the two depths and the calculator uses the average.

What about the pound-per-gallon rule?

CaribSea's FAQ says "the general rule is 1 to 2 pounds per gallon." For a 20 gallon high that means 20 to 40 pounds, and the 33 pounds worked out above for a 2 inch bed sits inside that range. On a 40 breeder the rule gives 40 to 80 pounds, and a 2 inch bed takes 73. The rule holds up as a sanity check, but it is a wide range, so measure if you are buying more than one bag.

Bags by product

  • CaribSea Super Naturals sand. CaribSea lists 5, 10, 20 and 40 pound bags of Moonlight Sand and Crystal River. Use the pounds figure above.
  • UNS Controsoil. Sold by the liter; UNS's guide lists 1, 3 and 10 liter amounts. Use the liters figure. The calculator counts 3 liter bags.
  • Seachem Flourite Black. Sold in 3.5 kg and 7 kg bags. Seachem doesn't print a volume per bag on its product page, so use Seachem's own gravel calculator (linked in the sources), which returns a bag count from the same three measurements.
  • Fluval Plant and Shrimp Stratum. Sold by weight (the bag linked below is 8.8 lb). We couldn't find a volume per bag from Fluval, so we haven't guessed at a bag count.
CaribSea Super Naturals Crystal River Sand, 40 lb
40 lb sand

CaribSea Super Naturals Crystal River Sand, 40 lb

  • Fine natural sand, 0.5 to 1.0 mm
  • pH neutral, no paints or dyes
  • Made in the USA (listing)
Check price on Amazon
CaribSea Super Naturals Moonlight Sand, 2 x 5 lb
2 x 5 lb sand

CaribSea Super Naturals Moonlight Sand, 2 x 5 lb

  • Very fine natural sand, 0.25 to 0.75 mm
  • pH neutral; won't raise hardness
  • Listing suggests at least 1 lb per gallon
Check price on Amazon
UNS Controsoil, Black, Normal, 3 L
3 L plant soil

UNS Controsoil, Black, Normal, 3 L

  • Soil and volcanic ash blend for planted tanks
  • Buffers toward pH 6.8 and lowers hardness (UNS)
  • No rinsing needed (listing)
Check price on Amazon
Fluval Plant and Shrimp Stratum, 8.8 lb
8.8 lb plant soil

Fluval Plant and Shrimp Stratum, 8.8 lb

  • Porous volcanic soil for planted and shrimp tanks
  • Supports a neutral to slightly acidic pH (listing)
  • Gives newborn shrimp places to hide
Check price on Amazon

Before you pour

Substrate takes up room. A 2 inch bed in a 20 gallon high fills about 10 liters of the tank, roughly 2.6 gallons of space, before rock and decor. If you dose conditioner or medication by volume, work from the water you actually have: see the aquarium volume calculator. A new bed also needs a cycled tank above it before fish go in; see how to cycle a fish tank.

FAQ

How much substrate do I need for my aquarium?

Multiply the tank's inside length by its width by the bed depth you want, all in inches. That is the volume in cubic inches. For sand, CaribSea's formula divides by 1,728 and multiplies by the sand's density; its Super Naturals sands are listed at 95 pounds per cubic foot. For soils sold by the liter, multiply cubic inches by 0.016387 to get liters.

How much sand for a 10 gallon tank?

A standard 10 gallon tank is 20 1/4 x 10 1/2 inches, per Aqueon. A 1 inch bed of CaribSea Super Naturals sand works out to about 12 pounds and a 2 inch bed to about 23 pounds, using CaribSea's formula and its listed density of 95 pounds per cubic foot. The arithmetic is ours.

How many pounds of gravel per gallon?

CaribSea's general rule is 1 to 2 pounds per gallon. It is a quick check, not a measurement, because it ignores the tank's shape and the depth you want. A long, shallow tank needs more than a tall one of the same volume.

How do I work out a sloped substrate bed?

Use the average depth. A bed that is 1 inch deep at the front glass and 3 inches at the back averages 2 inches, so it takes the same amount as a flat 2 inch bed. The calculator does this when you enter two depths.

Sources

  1. CaribSea: FAQ (How many pounds do I need?)
  2. CaribSea: Freshwater substrates
  3. Ultum Nature Systems: Controsoil
  4. Seachem: Gravel calculators
  5. Aqueon: Aquarium sizing information (PDF)
  6. NIST Handbook 44, Appendix C: units of measurement